BPC PowerMaster El manual del propietario descargar pdf (Pagina 17)

Configuring the BPC2 for ACCESSORY Addresses

To configure your BPC2 for ACCESSORY-Address Operation:

1. Turn power to your command base and LCS system on.

2. Press and hold the BPC2 PGM button for 1 second. The red LED will begin blinking slowly.

3. On your Lionel cab remote, press ACC to choose ACCESSORY-address operation.

4. Enter the 1 or 2 digit base address/TMCC ID.

5. Press SET. The red LED will go on solid for 1 second, and then continue flashing.

6. Now, you may optionally press the Coupler "R" button. Doing so turns on the "restore last

relay settings on power-up" feature.

7 Finally, set the 8 TMCC ID sub-mode. Press AUX1, then 0. The red LED will go on solidly

for one second, then turn off. The configuration process is complete.

The other sub-mode, 1 TMCC ID addressing, is reserved for future use and will not

function with a Cab remote.

To operate your BPC2 in ACCESSORY address mode::

1. Press the ACC button on your remote

2. Enter the ID number matching the address range set in the configuration step above. Hint:

thiswillbeequaltotheTMCCID/baseaddress(seestep4,above)oroneofthenextseven

numbers.

3. Press AUX1 to turn a power block on.

4. Press AUX2 to turn a power block off.

Example: If your BPC2 has a TMCC ID/base address of 64 and you want to control the track

powerblockwiredtothesixthscrewterminal,selecttheACCbutton,enter6,9(ID69)and

then AUX1 and AUX2 to turn that power block on and off.

Additional commands

TheBPC2willidentifybyholdingthenumeric“0”(LegacyReset)commandbyturning

on the RED PDI activity LED. This identifying mode will only work when using the TMCC ID

base address.

TheBPC2willturnoffalloutputsifanumeric“0”(Legacy“R”)commandisreceived.

The BPC2 will turn off all outputs if a “System Halt” command is received. Use the HALT

button only in emergency situations.

Note!

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

BPC PowerMaster El manual del propietario Pagina 17