BPC PowerMaster El manual del propietario descargar pdf (Pagina 12)

Installing additional LCS devices

his section describes adding a new device to an existing Layout Control System installation. If

you are installing a brand new LCS system, please refer to the previous section of this document,

“Installing Your First LCS Device.”

Adding additional LCS devices to an existing Layout Control System requires an additional

cable for each new device. These “LCS PDI Cables” come in a variety of pre-made lengths. They are

not included with LCS devices, and must be purchased separately. LCS PDI Cables are available in

a variety of lengths:

6-81500 - LCS PDI 1ft Cable

6-81501 - LCS PDI 3ft Cable

6-81502 - LCS PDI 10ft Cable

6-81503 - LCS PDI 20ft Cable

EachnewdeviceisconnectedviaLCSPDIcablesina“daisy-chain”fashion(onetothenext,and

soon).Theorderofdevicesinthe“chain”isuptoyou.TheonlyexceptionisthatanLCSWiFimust

be the first device in the chain if no Lionel Command Base is present.

To connect each additional LCS device:

1. Find the “last” LCS device in the chain. One if its two LCS PDI connectors will be in use, the other

will be empty.

2. Using your chosen length LCS PDI Cable, connect one cable end to the unused LCS PDI connector

of the last LCS device in the chain.

3. ConnectthesecondcableendtoeitheroftheLCSPDIconnectorsonyournewLCSdevice(see

figurebelow).YournewLCSdeviceisnowthelastoneinthechain.

LCS PDI CABLES

use either connector

SER2

6-81326

LCS PDI CABLES

use either connector

WiFi

6-81325

To LCS module or

command base

Figure 7. Installing additional LCS devices

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Sin comentarios

BPC PowerMaster El manual del propietario Pagina 12