BPC PowerMaster Manual de usuario descargar pdf (Pagina 5)

Wiring Your Block Power Controller

Connecting the COMM wires

o receive your commands, the BPC will need to communicate with the Command Base.

Messages from the Command Base are sent through the Command Base Cable (available

separately, 6-14191 for a 6’ cable or 6-14195 for a 20’ cable). Follow these steps and refer to

Figure 1 on page 4 to connect your BPC unit to the Command Base with the cable.

Your BPC is equipped with two additional COM terminals, AX + and AX-. At this

time, leave these terminals empty. These are intended for future capabilities. Do not

wire DAT and COMM wiring to the AX+ and AX- terminals.

1. Connect the DB9 Connector at the end of the Command Base Cable (the

end that looks like a computer cable) to the COMPUTER terminal on the

Command Base.

2. Connect the red wire at the other end of the Command Base Cable to the

DAT terminal on the BPC.

3. Connect the green wire to the COM terminal on the BPC.

Note!

1 2 3 4 5 6 7 8 9 10 ... 15 16

Sin comentarios

BPC PowerMaster Manual de usuario Pagina 5